Flexible Ribbon Led Strip 2-Line (Non-Waterproof) 6W/ft

Flexible Ribbon Led Strip 2-Line (Non-Waterproof) 6W/ft
Item# EL-RBL-2
$220.00, 5/$1,050.00, 15/$3,000.00, 20/$3,600.00
Colors: 

Product Description

EL-RBL2 features 2 line high bightness 3528 SMD Led's on a 16mm (5/8") wide PC board.
Input 24V DC
Dimmable
98 Watts per 5 meter Roll (16.25') - 6 Watt per foot
1200 pcs of SMD 3528 per Roll (5 meter / 16.25')
1350 lumens, 120 degrees
Colors available: Cool White (EL-RBL2-W), Warm White (EL-RBL2-WW), Yellow (EL-RBL2-YL), Green (EL-RBL2-GR), Blue (EL-RBL2-BL), and Red (EL-RBL2-RD)
Cuttable: Every 6 Led's (50mm / 1 15/16")

Product Dimensions



Possible applications with EL-RBL2

Cove lighting
Architectural lights for canopy, corridor, window, archway
Backlight or edge lighting for signage
DIY lights for home use- Path and contour marking
Decorative lights for holiday, event, show, exhibition

Assembly Information

Solder connection should only be performed on designated solder pads. During soldering, don't exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.

The smallest unit (50mm - 6 LEDs) can be removed by cutting with scissors between the designated solder pads.

The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip.

Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt partide.

The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing.

Once the strip is appropriately positioned. Press on the strip with about 20N/cm2 (refer to ap-plication techniques of 3M adhesive transfer tapes).

The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board contain-ing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.

Safety Information

The strip itself and all its components may not be mechanically stressed.

Assembly must not damage or destroy conducting paths on the circuit board.

Installation of LED ribbon (with power supplies) needs to be made with regard to all applicable electrical and safety standards. Only qualified personnel should be allowed to perform installations.

Correct electrical polarity needs to be observed. Wrong polarity may destroy the strip.

Parallel connection is highly recommended as safe electrical operation mode.

Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload and damage the strip.

Please ensure that the power supply is of adapters power to operate the total load.

When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation points between strip and the mounting surface.

Pay attention to standard ESD precautions when installing the strip.

Damaged by corrosion will not be honored as a materials defect claim. It is the user's responsibility to provide suitable protection against corrosive agents such as moisture and condensation and other harmful elements.